A. Two ways; overdrive the motor (for example, drive a 1760 rpm motor over 1800 and then either… 1. Connect it to an AC sine signal (usually connect to the Grid at 50 or 60 Hz) or… 2. Give the motor a jolt of DC current to ‘excite’ the...
With Capacitive Power Supply (CPS) technology, the real wattage is the LOAD amperage and voltage; not the SOURCE amperage and voltage. For a battery charger the ‘load’ is the battery; so you measure the amperage going into your battery and the voltage of...
Ahhhh 🙂 Very good question 🙂 I used to make a HyCO 2A kit when my customers were mostly carbureted. The HyCO 2A didn’t work well on Fuel Injected systems because the MAP Sensor ‘read’ the input as a ‘vacuum leak’ which cause the...
Only if you use the ‘air pocket’ technique commonly used with oxy./acet. is used under water and the water depth is not too deep because BG cannot be pressurized too much or it will explode.
I recommend 25% lye to water by weight. I understand that may be a little confusing because people ask “Is that 250 grams for 1 liter or 250 grams for 750 CC?” Actually it isn’t that critical and either will work. I usually use the former and the...
